has been added to your cart
View Cart

Square Downpipe

SKU: Square-Downpipe

Square and rectangular downpipes offer a clean, modern finish due to their ability to sit flush against a wall. Stratco Square and Rectangular spouts are available in a size to suit any project. Whether you want to install it yourself or require assistance, we are here to help. Contact us for pricing and further details today.
Available in QLD

Square Downpipes

Downpipe styling designed to adapt to any architecture

Designed to sit flush against the wall, Square and Rectangular Downpipes offer a clean, modern finish to architecture. Square and Rectangular Downpipes are available in a large range of sizes for both domestic and commercial applications. Complete your project with an extensive range of Square Downpipe accessories.

Available Colours:

Square Downpipe Accessories

Downpipe straps can be supplied to easily attach the downpipe to the wall of the building. Shoes (135°) and elbows (90°) are available to help water flow to a specific area. Downpipe outlets are an added accessory to help channel water from the gutter to the downpipe.

Note: Component availability is state specific, please check prior to ordering.

Downpipes-Downpipe-Spouts-Spouting-Square-Accessory-01.jpg

Adjustable Two Piece Offset

Downpipes-Downpipe-Spouts-Spouting-Square-Accessory-02.jpg

Downpipe Elbow

Downpipes-Downpipe-Spouts-Spouting-Square-Accessory-03.jpg

Downpipe Shoe

Downpipes-Downpipe-Spouts-Spouting-Square-Accessory-04.jpg

Sculptured Outlet

Downpipes-Downpipe-Spouts-Spouting-Square-Accessory-05.jpg

Downpipe Outlet

Downpipes-Downpipe-Spouts-Spouting-Square-Accessory-06.jpg

Downpipe Strap

As a general guide, in non cyclonic areas, for every 1m2 of roof area drained, 70mm2 of downpipe is required. This calculation is based on the assumption that the maximum rainfall does not exceed 125mm per hour.

It is considered the best practice to drain to different points, using smaller downpipes rather than to one large outlet. Where possible, downpipes should be spaced at not more than 12000mm centres.

For a more accurate guide, consult the Installation Code for Metal Roofing and Wall Cladding SAA HB39-1997.

Material Specification

BMT - 0.40mm and 0.50mm
Tensile - G300 MPa

Downpipes Downpipe Spouts Spouting Square Profile

Downpipe Sizes
Size A x B (mm) Roof Area Drained (m²)
50 x 50* 35
75 x 50 55
75 x 75 80
95 x 45 60
100 x 50 70
100 x 75 105
100 x 100 140
125 x 100 180
150 x 100 210
150 x 150 320
200 x 200 570

*1800mm lengths only

0 days
00 hours
00 minutes
00 seconds

Change Location

Please enter a valid postcode